Γλώσσα: [el]

The actual control commands are transferred in the command byte. The following is a very small extract listing the commands:

Hex Byte	Command	Function
00	Reset	Restarts the slave micro controller
02	Standby	Makes device fall into standby mode
03	Power on	Makes device awake from standby mode
07	Address	Reading of slave address
10	Status	Reading of status register
11	Config	Reading of Configuration register
14	Switch 0	Reading of available switches and current switch states
20	Set Lo	Selection of low band
21	Set VR	Selection of vertical polarization (or right circular)
22	Set Pos A	Selection of satellite system A
23	Set S0A	Options switch state A
24	Set Hi	Selection of high band
25	Set HL	Selection of horizontal polarisation (or left circular)
26	Set Pos B	Selection of satellite system B
27	Set S0B	Options switch state B
38	Write N0	Command to describe the entire IF path
50	LO string	Reading of the local oscillator frequency (BCD Value)
51	LO now	Reading of current local oscillator frequency
52	LO Lo	Reading of low local oscillator frequency
53	LO Hi	Reading of high local oscillator frequency

πίσω στον πίνακα περιεχομένωνπροηγούμενη σελίδαεπόμενη σελίδα

Σελίδα 7 / 29

  Έκδοση τυπωμένων υλών

Κορυφή